RESEARCH QUESTION AND HYPOTHESIS
To what degree will new bicycle facilities reduce driving? We present a simple method for projecting the impact of new bicycle facilities on vehicle kilometers traveled (VKT).
METHODS AND DATA
We developed an equation for projecting VKT reductions resulting from new bicycle facilities using existing short-duration bicycle counts on or near the facility corridor. We then reviewed the English-language literature related to the variables in our equation to gauge the feasibility of measuring each and the range of their potential values. We focus on Class I bicycle paths (separated right-of-way for exclusive bicycle use), Class II bicycle lanes (on-street lanes designated for bicycle use), and Class IV cycle tracks (on-street lanes protected from vehicular traffic by barriers like posts).
FINDINGS
Our method starts from the premise that bicycle “ridership change can be predicted reasonably reliably by volumes observed before facility installation” (Matute et al. 2016). Our equation takes an hourly (or daily) pre-installation bicycle count on or near the corridor of the proposed facility, then applies six adjustment factors to project annual VKT reductions induced by adding the facility (see Figure 1).
The pre-facility-installation bicycle count, F, will vary by project. Best practices for collecting bicycle counts are well established (e.g., Ryus et al. 2014).
The seasonal adjustment factor, S, has a dual purpose of converting the short-term bicycle counts to yearly count estimates and adjusting for the substantial temporal and seasonal variation found in bicycling counts (Jones et al. 2010; Nordback and Sellinger 2014; Skov-Petersen et al. 2017). A year’s worth of continuous bicycle count data from even a single counter can be enough to calculate local seasonal adjustment factors (Nordback and Sellinger 2014). Researchers have also attempted to develop more generally applicable seasonal adjustment factors for use in areas without sufficient local bicycle counts (e.g., National Bicycle and Pedestrian Documentation Project. 2009).
The growth factor, G, represents the expected rate of increase in bicycle usage after facility installation. Multiplying the seasonally-adjusted pre-installation bicycle count by the growth factor yields an estimate of the additional annual bicycle trips on the route. Table 1 shows the range of growth factor values from studies that reported facility-level ridership changes after bicycle facility additions.
The low number of new facilities with reported before and after counts specific for bicycling makes it difficult to discern how the growth factor changes by facility type, length, or connectivity. While this presents an obvious need for future research, the results do indicate that ridership increases close to 100% (G = 1.0) are not uncommon along the routes of new Class I, Class II, and Class IV facilities.
The results also indicate that the magnitude of the percentage increases may remain relatively stable regardless of the bicycle counts before facility installation, therefore indicating that pre-facility-installation bicycle counts can be a reasonably reliable predictor of counts made after installation (Matute et al. 2016; Goodno et al. 2013). The growth factor will vary depending on context and is likely to vary more for facilities in areas with very high or very low existing bicycling levels. The before-and-after studies available for areas with high existing bicycling levels generally found growth rates comparable to the others; for example, there was a 119% increase in Davis, California (Gudz, Fang, and Handy 2016) and an 87% increase in Oakland, California (McClain and Peterson 2016). Conversely, studies in areas with very low base bicycling rates showed minimal to no increases in bicycling following infrastructure improvement (Brown et al. 2016; Burbidge and Goulias 2009; Evenson, Herring, and Huston 2005). However, it would take a rate much higher than 1.0 to appreciably change VKT reduction estimates in those areas.
The trip type factor, T, decrements the post-facility-installation bicycle count projection by the average percentage of bicycle trips made for recreation (e.g., as derived from a household travel survey). But the adjustment may lead to a conservative projection. At least one study indicates that bicycle facilities influence an individual’s choice to bicycle instead of drive for utilitarian and recreational purposes (Matute et al. 2016). Furthermore, the studies from which we gleaned the auto–bicycle substitution rates calculated the rates from all surveyed cyclists, not just utilitarian cyclists (Matute et al. 2016; Monsere et al. 2014; Thakuriah et al. 2012).
The auto substitution factor, A, and carpool factor, C, convert the projected additional bicycle trips into avoided automobile trips. Auto substitution represents the percentage of additional bicycle trips that would have otherwise been made by automobile. The rate is generally much lower than the existing auto mode share in the corridor because most of the “new” cyclists would have also cycled before installation of the new infrastructure, just on a different route. The available data indicate an auto substitution rate of about 0.1, mostly based on data from intercept surveys on Class IV facilities (Matute et al. 2016; Monsere et al. 2014; Thakuriah et al. 2012). The carpool factor corrects for the fact that not all those shifting from auto to bicycle would have driven alone previously and is the reciprocal of the relevant average vehicle occupancy.
The trip length factor, L, converts the projected reduction in automobile trips into avoided VKT. Data on average bicycle trip length (usually 3–5 km) can be used here (e.g., from national, state, or regional household travel surveys).
While data on some variables in our equation remain sparse, it is increasingly possible to project VKT reductions from new bicycle facilities using existing short-duration bicycle counts. Table 2 presents potential default values for the independent variables in our equation, except the site-specific bicycle count and seasonal adjustment factor. We chose California as the example region in setting values for the carpool factor and bicycle trip length.
Table 3 applies the default factors from Table 2 to estimate the annual VKT reduction from the 2014 installation of Class II lanes eastbound and westbound on a 1.3 km section of Fifth Street in Davis, California. The result is an annual VKT reduction of 77,512.
ACKNOWLEDGMENT
The research presented in this article was funded by the California Air Resources Board (contract 16TTD004). The statements and conclusions in this article are those of the contractor and not necessarily those of the California Air Resources Board. The mention of third‑party sources, or their use in connection with material reported herein, is not to be construed as actual or implied endorsement of such sources.